Can Engineered Wood Be Refinished

Engineered wood can potentially be refinished but this is wholly dependent on the thickness of the top layer of wood.

Can engineered wood be refinished.

Cannot be sanded and refinished. Most wear layers on today s engineered hardwood floors vary between 5 to 6mm. Engineered hardwood flooring can be refinished though not as many times as solid hardwood. A thicker wear layer means your floor can be sanded and refinished more often increasing the lifespan of the floor.

Even at 3mm if the floor is lumpy you risk sanding through to the ply substrate. In most cases yes. As we previously discussed refinishing engineered wood is a delicate process in that there isn t as much actual wood that can be sanded away. Engineered wood flooring is usually 4 8mm and is good for sanding and refinishing.

This of course depends on they quality of the wood thickness of top layer and installation method see below. Can engineered wood flooring be sanded and refinished. Can your engineered floor be refinished. If you have an engineered hardwood installed that is damaged due to traffic dented and scratched before sanding down at it there are a few things to consider.

Refinishing engineered wood flooring is a great solution for most homeowners. If it s floating meaning that it s not attached to the floor. As a general rule solid hardwood can be refinished but most engineered hardwoods can not. That depends on how many times it has been refinished before and how thick the wear layer is.

Solid wood which is made of actual planks of real wood and engineered wood. Many customers are surprised to learn that engineered hardwood can indeed be refinished once and sometimes more. A 3mm wear layer can be refinished up to three times and a 4mm or greater wear layer should not be refinished more than five times. It all depends on the thickness of the wear layer.

There are two types of prefinished hardwood floors. Some things to consider are the type of wood the current color and if it s been refinished before. Indications that your hardwood may be engineered. Only recoated with a layer of urethane.

Can be sanded and refinished 1 to 2 times. Engineered wood floors with a top layer that is less than 2 mm thick can be screened which is the process of removing the urethane and applying a new coat but they cannot be refinished. If you have the solid wood type you can absolutely refinish it usually between four and seven times before the floor would need to be completely replaced. By the way this discussion applies to engineered parquet flooring too.

Here are the general guidelines to keep in mind 5 to 1mm wear layer.